Hello!Welcome to Zhuzhou Mingri Cemented Carbide Co., Ltd.!

搜索
Search

Hotline:
0731-22878222

这是描述信息
imgboxbg

Standard parts

All categories
imgboxbg

Blades serious

All categories
All categories
Your present location:
Homepage
/
/
/
/
/
Cemented Carbide Strip for Sand Making Machine with Non-Magnetic
1/1

Cemented Carbide Strip for Sand Making Machine with Non-Magnetic

Product serial number
Carbide strip05
Category
Strip
Quantity
-
+
1
description

 公司图片

车间

Recommend grade list of tungsten carbide strips and plates:
 

Grade Density g/cm3 Hardnes HRA T.R.S Mpa Performance&application recommended
YG6A 14.85 92.5 2000 Fine grain alloy,good wear resistance.it is suitable for manufacturing forming cutter,wear-resistant parts etc.
YG8 14.7 89.8 2800 High bending strength,wear resistance lower than YG6A, suitable for manufacturing cutter ,wear-resistant parts etc.
YG11 14.4 88.5 2900 High bending strength,wear resistance lower than YG6A, suitable for manufacturing cutter ,wear-resistant parts etc.
YG15 14.0 87.0 3000 Suitable for manufacturing punching dies, wear-resistant parts.
YG20 13.5 85.5 2800 High bending strength,suitable for manufacturing progressive dies and other punching dies.
YG25 13.1 81.5 2950 High bending strength,wear resistance lower than YM6A, suitable for manufacturing cutter ,wear-resistant parts etc.
YS2T 14.25 92.0 2500 Fine grain alloy, with high wear resistance, bending strength, bonding resistance and thermal strength. it is suitable for machining refractory alloys,stainless steel, high manganese steel, etc.

 

Product size reference:
 

Type (L×W ) Thickness (H) Tolerance
Length (L) Width (W) Height (H)
50×50× 1.5~10 L×±1.5% W×±2.5% H×±2.5%
100×100× 2.5~60
120×120×
150×150×
200×200×
300×200×

To ensure the quality and the requirements of the drawings can be met before mass production
1st:, Start to prepare the RTP powder as per customer's requirement with our wet-grinding machine
2nd, Before mass production, do a trial pressing and sintering using mould,

3rd, Check the appearances and the sizes of the samples with micrometer, projectors etc. 

Test process of Hard Alloy Carbide Roller Press HPGR Studs Pin for Crushing Iron Ore

1st,Mass production, press the raw materials to shape blanks,
Notes: all carbide stud pins blanks must be passed by semi finished inspection 

2nd,Sinter blanks to finish (HIP) and finished products inspection,
Notes:10 sets of vacuum sintering furnace and 2set of HIP in the factory ensure the best quality and production capacity.
 
3rd,Cleaning/tumbling to make the carbide stud pins clean and nice surface.

Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table

Page rights reserved:Zhuzhou Mingri Cemented Carbide Co.  IPv6 supported  湘ICP备10204182号-1  www.300.cn